MCP39xx with Current Transformer (CT)

Is is possible to use the MCP39xx metering devices with a current transformer instead of a shunt resistor?

The MCP3901 evaluation board has footprints for current transformers. From the MCP3901 product page, select the "MCP3901 Low-Cost Power Monitor Reference Design User's Guide" under Documents > User Guides.

For MCP3905, see Figure 2-9 in "MCP3905A/6A Evaluation Board User's Guide" under Documents > User Guides.

For MCP39F501/MCP39F511, there are no examples with a CT because the MCP39F501 and MCP39F511 were designed for working with a shunt, which is a cheaper current sensor. Theoretically, a CT should work as well, provided that the correct resistor load is chosen and the voltage at the ADC inputs are kept within the specified limits. The phase error is usually larger for a CT than for a shunt, so this may pose a problem with the phase compensation if it is outside the limits (+/- 3.2°).

© 2018 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.