Can I Configure the CCP1 module as PWM to blink LEDs on an MPLAB® Xpress Evaluation Board?

The CCP1 output is not directly connected to the RA0-RA7 pins on the board. There are two options to configure CCP1 to blink the LED:

  1. Connect an LED on RB0 or any other pin that is directly connected to the CCP1 output (J7 connector on the board) and configure the CCP1 mode as PWM with MCC.
  2. Use a CLC module to map the CCP1 output to PORTA and configure the CCP1 module as PWM with the CLC module to map the CCP1 out to the RA0 pin.

Some useful links to gain a better understanding of the CLC module:

© 2018 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.