Programming of Devices

Once the SQTP file has been produced, load the file into MPLAB® IPE (Figure 1). MPLAB IPE will then program the first device with basic code (including configuration bits) and the first serial number from the SQTP file. Next, it will program the second device with basic code and the second serial number. This will continue until the end of the SQTP file or number of devices to be programmed is reached. Then, depending on the settings under the Settings button, SQTP section (Figure 2), programming will halt or continue at the top of the file.

Figure 1: MPLAB IPE Operate - SQTP File Selection

MPLABIPE_Operate_Crop.png

Figure 2: MPLAB IPE Settings - SQTP Section

MPLABIPE_Settings_SQTP.png
© 2017 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.