SCL Concepts

This section discusses some higher level concepts that are necessary to understanding and using SCL before getting into the language details.

What SCL Does

SCL allows the user to inject external values into the simulated PIC environment while the simulator is executing the user's project code. For example, SCL can be used to toggle the INT0 pin to cause an interrupt to occur.

Given that the Simulator is, well, a simulation, timing of injection can be tricky. Events that happen simultaneously on the real hardware necessarily happen sequentially in the simulation. It is necessary to understand how the Simulator works to know when to inject.

The Simulator's fundamental process is to execute an instruction from the user's software image. For example, when "running", the Simulator is actually just executing one instruction after another. Of course the Simulator also simulates peripherals and handles SCL injections too. Here is the basic single-step flow:

   execute user instruction
   for each Tcyc needed by instruction   // might be more than 1 Tcyc!
      increment stopwatch
      process each peripheral
      run SCL processes

What is important here is to note that SCL injection won't occur until after the instruction has been executed. Usually the SCL author doesn't have to worry about cycle accuracy to such a fine level. But when injections absolutely have to occur at a specific instruction cycle, remembering the above process flow can be invaluable.

Running SCL Processes

The run SCL processes step in the above single Step flow was a bit vague. What exactly happens when the Simulator runs SCL processes?

(If you are new to SCL and the next part is confusing, skip it for now. It will make more sense after you've played with SCL for a bit!)

SCL maintains two process queues, active and inactive. When SCL runs it's processes, each process on the inactive queue is checked to see if that process can be moved to the active queue. (This is usually determined by the arguments to the wait statement that put the process on the inactive queue.) Then each process on the active queue is executed until another wait statement is encountered, putting the process back on the inactive queue.

This sequence is repeated until no SCL processes remain on the active queue. In particular note that a process can encounter a wait condition that will immediately move it back to the active queue. For example assume the wait statement is "wait until STATUS.Z == 1". If the STATUS.Z register field is currently 1, then the process will move to the inactive queue and immediately move back to the active queue and continue executing. All within the same simulation Tcyc!

© 2017 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.