Switch from Non-JTAG to JTAG Hardware

Non-JTAG communication hardware includes:

  • Standard/ICSP communication hardware
  • High-Speed/LVDS communication hardware (Performance Pak - AC244002)
  • The Performance Pak plus the Isolator Unit (AC244005)

To switch the hardware:

  1. While connected to the target by the standard communications cable, erase the target device. You may need to add Erase Device Memory Main Project to a toolbar using View >Toolbars > Customize.

If the target device has been programmed for debug (during a Debug Run) using non-JTAG hardware, the target MUST BE ERASED before switching from non-JTAG to JTAG.

  1. Power down the target board.
  2. Disconnect the standard communications cable from the target, disconnect the USB cable from the emulator, and unplug the standard driver board from the emulator.
  3. Connect one end of the ribbon cable to the connector on the JTAG adapter board (it should plug in only one way) and insert the JTAG adapter board into the emulator driver board slot.
  4. Connect the other end of the ribbon cable to the connector on a target board, such as the Microchip Explorer 16 development board. The plug is keyed to fit only one way.
  5. Connect the USB cable to the emulator and power the target board.

To set up MPLAB X IDE for JTAG operation:

  1. Select File > Project Properties. In the Project Properties dialog, click on your desired configuration, e.g., “Conf: [default]”.
  2. Click the down arrow on the Supported Plugin Board drop-down box and select JTAG Driver Board. Click OK to accept the setup.

Figure: Select JTAG Operation In MPLAB X IDE

JTAG_Adapter_MPLABX_Support.jpg
© 2017 Microchip Technology, Inc.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.