Performance Pak Emulator-to-Target Connections

The high-speed driver board from the Performance Pak is plugged into the emulator pod to configure the system for this type of communication with the target. The modular cables can be inserted into matching connectors on the high-speed receiver board.

The high-speed receiver board is attached via an 8-pin connector on one of the following:

  • Target board, with an on-board target device as shown in Figure 1
  • Debug or emulation header, which is then plugged into the target board as shown in Figure 2

Figure 1: High-Speed/LVDS Connection – Device with On-Board ICE Circuitry

PP_Connection1.jpg

Figure 2: High-Speed/LVDS Connection – Debug or Emulation Header

PP_Connection2.jpg

* See also Isolator Unit Connections

© 2017 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.