Emulator Operation

There are two steps to using the MPLAB® REAL ICE™ in-circuit emulator system as a debugger:

  1. An application (and the debug executive) must be programmed into the target device.
  2. The internal in-circuit debug hardware of the target Flash device must run and test the application program.

Those two steps are directly related to the following MPLAB X IDE operations:

  • Programming the code into the target and activating special debug functions.
  • Debugging the code using features such as breakpoints.

If the target device cannot be programmed correctly, the MPLAB REAL ICE in-circuit emulator will not be able to debug.

The figure below shows the basic interconnections required for programming and debugging. For simplicity, the Vdd and Vss lines from the emulator are not shown.

Figure: Proper Connections for Programming

EmulatorProperConnections.jpg

For programming, no clock is needed on the target device, but power must be supplied. When programming, the emulator puts programming levels on Vpp, sends clock pulses on PGC and serial data via PGD. To verify that the part has been programmed correctly, clocks are sent to PGC and data is read back from PGD. This conforms to the ICSP protocol of the device under development. See your device programming specification for details.

© 2018 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.