Power Monitor Selection as Plugin Board

To select the Power Monitor in MPLAB® X IDE, perform the following actions:

1

Open a Project

Open an MPLAB X IDE project.

2

Open Project Properties and Select Board

Select File > Project Properties. Click the down arrow on the “Supported Plugin Board” drop down box and select “Power Monitor”. Click Apply.

​

Note: If you receive a message stating that the Power Monitor cannot be detected, review your hardware connections.

Figure: Project Properties – Supported Plugin Board

SelectPowerMonitor.gif

3

Next Step:Target Board Power Selection

Proceed to Target Board Power Selection.

  Return to Top

© 2019 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.