Step 1: Connect Hardware
Step 1.1: PIC18F57Q43 Curiosity Nano Evaluation Board Connections
Connect PIC18F57Q43 Curiosity Nano Board and Curiosity Nano Adapter Board using 100 mil header strip.
Note: Soldering is not required. The adapter and evaluation boards have offset vias to provide press-fit to secure headers without soldering.
Step 1.2 – Connect Potentiometer to Curiosity Nano Adapter Board
Use three jumper wires to connect the potentiometer to Vdd, Vss and RA0 of MCU1 Curiosity Nano Adapter Board.
Step 1.3 – Attach a Jumper Wire from MCU1 UART TX to MCU2 UART RX
Use one jumper wire to connect MCU1 TX to MCU2 RX.
Step 1.4 - Verify Jumper Connections
Here’s how the setup should look after all connections have been made: