SD card Driver ConfigurationRETAIN/CHANGERemark
Use SD Card Driver CHANGEThe SD card is used to store images and the webpage, so you need to enable the SD card driver. Unchecked by default. Select this option.
 Driver ImplementationRETAINSelected as Dynamic by default. You cannot change this option. Retain this.
 Number of SD Card Driver ClientsCHANGESD card is used by the Graphical Display as well as the TCP/IP stack, to read the images. Default is one. Change this to two.
 SD Card Driver IndexRETAINDefault is DRV_SDCARD_INDEX_0. Retain this.
 Maximum Driver IndecesCHANGEYou are using two instances of the SD card driver. Change this to two.
 SD Card Data Queue SizeRETAINDefault value is 10. Retain this.
 Clock To UseCHANGEDefault is CLK_BUS_PERIPHERAL_1. Change it to CLK_BUS_PERIPHERAL_2, because CLK_BUS_PERIPHERAL_2 is a clock source for the Serial Peripheral Interface (SPI) module. The SPI module is used by the SD Card driver as the communication interface module.
 SD Card Speed(Hz)RETAINDefault is 20000000. Retain this.
 Eneble Write Protect Check?CHANGEDefault write protect check is enabled. Micro SD cards do not have write protection line. Disable this option.
 Chip Select PortCHANGEDefault is PORT_CHANNEL_A. Change this to PORT_CHANNEL_B. For SD Card operating in SPI mode, the DATA3/CD line of SD Card is used as chip select line and the same is connected to port pin RB14
 Chip Select Port BitCHANGEDefault is PORTS_BIT_POS_1. Change this to PORTS_BIT_POS_14. For SD Card operating in SPI mode, the DATA3/CD line of SD Card is used as chip select line and the same is connected to port pin RB14
 SPI Driver Instance to use for SD Card DriverRETAINDefault is 0. Retain this.
 Register With FilesystemRETAINYou access the contents of the SD card as files, therefore the SD card must be registered with the FileSystem. Default is checked. Retain this.