Power Data Only Mode

The Power Data Only mode provides power samples consisting of a time stamp, voltage, and current.


Select Trace and Profiling Category

In the Project Properties window, click the “Real ICE” category and select the “Trace and Profiling” option category.


Select and Enter Setup Data

Under “Target Power Sampling Selection”, “Power Data Only” will be selected.

  • Under “Power Measurement”, select “Target Board (1mA - 1A)”. To measure the power consumption of only the microcontroller, see Device Power (CHB) Setup.
  • Under “Target Power Sampling Interval (in microseconds)”, enter a value.

Figure: Power Data Only Mode Setup



Accept Settings

Click Apply if you want to select additional power settings or OK to close the Project Properties window.

© 2020 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.